Cambium Networks PTP 820 Series User Manual page 905

Chapter 19: Quality of Service (QoS) (CLI)
Attaching a Shaper Profile to a Service Bundle (CLI)
You can attach one of the configured service bundle shaper profiles to each service bundle. If no profile is attached
to the service bundle, no egress shaping is performed on that service bundle.
To attach a service bundle shaper profile to a service bundle, go to interface view for the service bundle and enter
the following command:
eth type eth [x/x]> service-bundle-shaper add capability service-bundle-
id <service-bundle-id> admin-state <admin-state> profile-id <profile-id>
To change the service bundle shaper profile attached to a service bundle, go to interface view for the interface and
enter the following command:
eth type eth [x/x]> service-bundle-shaper edit service-bundle-id
<service-bundle-id> admin-state <admin-state> profile-id <profile-id>
To display the service bundle shaper profile attached to a service bundle, go to interface view for the interface and
enter the following command:
eth type eth [x/x]> service-bundle-shaper show configuration service-
bundle-id <service-bundle-id>
To remove a service bundle shaper profile from a service bundle, go to interface view for the interface and enter
the following command:
eth type eth [x/x]> service-bundle-shaper delete service-bundle-id
<service-bundle-id>
Table 244 Attaching Shaper Profile to Service Bundle CLI Parameters
Parameter Input Type
service- Number
bundle-id
admin-state Variable
profile-id Number
The following command adds Service Bundle Shaper Profile 5 to Service Bundle 1, on Ethernet port 1, and enables
shaping on this service bundle:
eth type eth [1/1]> service-bundle-shaper add capability service-bundle-
id 1 admin-state enable profile-id 5
The following command changes the Service Bundle Shaper Profile assigned in the previous command to Service
Bundle 1, from 5 to 4:
Permitted Values Description
1 – 63 The service bundle to which you are
attaching the queue shaper profile.
Note: In the
current release, only
Service Bundle 1 is
supported.
enable Select enable to
on the service bundle, or
disable
disable egress shaping on the service
bundle.
1 – 256 Enter the ID of one of the configured
service bundle shaper profiles.
phn-3965_006v002
Page 19-38
Configuring Shapers (CLI)
enable egress shaping
disable to