Cambium Networks PTP 820 Series User Manual page 827

Chapter 18: Ethernet Services and Interfaces (CLI)
Table 179 Ethernet Service Default CoS CLI Parameters
Parameter Input Type
cos Number
The following commands configure Service 10 to assign a CoS value of 7 to frames traversing the service:
service[10]>service cos-mode set cos-mode default-cos
service[10]>service default-cos set cos 7
The following command configures Service 10 to preserve the CoS decision made at the interface or service point
level for frames traveling through the service:
service[10]>service cos-mode set cos-mode preserve-sp-cos-decision
Configuring a Service's EVC ID and Description (CLI)
To add or change the EVC ID of a service, go to service view for the service and enter the following command:
service[SID]>service evcid set <evcid>
To display a service's EVC ID, go to service view for the service and enter the following command:
service[SID]>service evcid show
To add or change the EVC description of a service, go to service view for the service and enter the following
command:
service[SID]>service description set <evc description>
To display a service's EVC description, go to service view for the service and enter the following command:
service[SID]>service description show
Table 180 Ethernet Service EVC CLI Parameters
Parameter Input Type
evcid Text String
To display a service's EVC ID, go to service view for the service and enter the following command:
service[SID]>service evcid show
To add or change the EVC description of a service, go to service view for the service and enter the following
command:
service[SID]>service description set <evc description>
Permitted Values Description
This value is assigned to frames at the service level
0 – 7
if
cos-mode
this value is not used, and frames retain whatever
CoS value they were assigned at the service point
or logical interface level.
Permitted Values Description
Up to 20 Defines an Ethernet Virtual Connection (EVC) ID.
characters. This parameter does not affect the network
element's behavior, but is used by the NMS for
topology management.
phn-3965_006v002
Page 18-8
Configuring Ethernet Services (CLI)
is set to . Otherwise,
default-cos