Cambium Networks PTP 820 Series User Manual page 72

Chapter 1: Introduction
•
Radio Receiver – Receiver PMs and statistics, including defective blocks, modem MSE, and RX level,
modulation, and bit rate. For additional information, see
View (CLI)
•
To view and configure radio parameters, you must first enter the radio's view level in the CLI.
Use the following command to enter a radio's view level:
root> radio slot <slot> port <port>
The following command enters radio view for fixed radio interface 1:
root> radio slot 1 port 1
The following prompt appears:
radio[1/1]>
The following command enters radio view for fixed radio interface 2:
root> radio slot 1 port 2
The following prompt appears:
radio[1/2]>
The following command enters radio view for an RMC in expansion slot 3:
root> radio slot 3 port 1
The following prompt appears:
radio[3/1]>
The Web-Based Element Management System
Configuring the Radio Parameters
phn-3965_006v002
Page 1-26
and Entering Radio