Cambium Networks PTP 820 Series User Manual page 793

Chapter 17: Radio Configuration (CLI)
Configuring the Remote Radio Parameters (CLI)
This section includes:
•
Displaying Communication Status with the Remote Radio (CLI)
•
Displaying the Remote Radio's Link ID and Location (CLI)
•
Muting and Unmuting the Remote Radio (CLI)
•
Displaying the Remote Radio's RX Level (CLI)
•
Configuring the Remote Radio's TX Level (CLI)
•
Configuring Remote ATPC (CLI)
Related topics:
•
Configuring the Remote Unit's IP Address (CLI)
Displaying Communication Status with the Remote Radio (CLI)
To display the communication status with the remote radio, go to radio view and enter the following command in
radio view:
radio[x/x]>remote-unit communication status show
Displaying the Remote Radio's Link ID and Location (CLI)
To display the remote radio's Link ID, go to radio view and enter the following command:
radio[x/x]>remote-unit show link-id
To display the remote radio's slot ID (location in the chassis), enter the following command in radio view:
radio[x/x]>remote-unit show slot-id
Muting and Unmuting the Remote Radio (CLI)
To mute or unmute the remote radio, go to radio view and enter the following command:
radio[x/x]>remote-unit mute set admin <admin>
To display the mute status of the remote radio, go to radio view and enter the following command:
radio[x/x]>remote-unit mute show status
Configuring the Remote Radio Parameters (CLI)
phn-3965_006v002
Page 17-4