Cambium Networks PTP 820 Series User Manual page 985

Chapter 21: TDM Services and Interfaces (CLI)
Parameter Input Type
pw-profile-id Number
psn-tunnel-id Number
src-ecid Number
dst-ecid Number
cr-master-pws Variable
protected Variable
The following commands configure and enable service 12, on the E1/DS1 interface:
pwe3> pwe3 pws satop-eth add slot 1 id 12 tdm-port 9 pw-profile-id 5 psn-
tunnel-id 7 src-ecid 31 dst-ecid 131 cr-master-pws no protected no
pwe3> pwe3 pws enable slot 1 id 12
To verify the configuration of the service you just created, enter the following command:
Permitted Values Description
1-64 The pseudowire profile used with the
service. The pseudowire profile
determines the behavior of the service,
including the buffer, payload
suppression, and other parameters. A
profile can be used by multiple services.
1-168 The pseudowire tunnel used with the
service. The tunnel determines how
traffic over the service passes through
the network. In this version,
encapsulation must use the MEF-8
protocol. Up to 16 tunnels can be
configured for each TDM card in the
chassis.
If the
yes
identifies a tunnel group rather than a
tunnel.
1-1048575 The source ECID for the Ethernet tunnel.
1-1048575 The destination ECID for the Ethernet
tunnel.
yes Enter yes to use this service as a
no reference for clock recovery. Otherwise,
enter no.
yes Enter yes to create a protected path
no service. Otherwise, enter no.
If this parameter is set to yes, the psn-
tunnel-id parameter identifies a tunnel
group rather than a tunnel, and the
service is configured as a path-protected
service. For more information on
pseudowire path protection, refer to
Configuring Pseudowire Path Protection
and Dual Homing
phn-3965_006v002
Page 21-24
Configuring TDM Pseudowire Services (CLI)
parameter is set to
protected
, the parameter
psn-tunnel-id
(CLI).