Chapter 9: TDM Services and Interfaces
3
Configure the parameters, as described in
Table 102 Pseudowire Card Configuration Parameters
Parameter
Shelf Slot ID
Ethernet Traffic MAC Address
Signal to System Sync
Distribution Reference
TDM Port for System Clock
Recovery Reference
Card Clock Recovery Mode
Table
102.
Definition
Read-only. Slot 1.
Displays the E1/DS1 connector's MAC address, which is unique per unit.
This means if the E1/DS1 connector is replaced, the MAC address remains
the same, and no configuration changes are required.
Select the clock source that the TDM interface exports to the general PTP
820G or PTP 820F synchronization mechanism. Options are:
•
None – No clock source is exported from the TDM interface to the
general PTP 820G synchronization mechanism.
•
Front Panel – Reserved for future use.
•
Clock Recovery – Reserved for future use.
•
clock-1588 – Reserved for future use.
•
rx-pdh – Reserved for future use.
•
rx-sdh – Reserved for future use.
Reserved for future use.
Reserved for future use.
phn-3965_006v002
Page 9-45
Configuring Advanced Pseudowire Parameters