Configuring In-Band Management - Cambium Networks PTP 820 Series User Manual

Chapter 2: Getting Started

Configuring In-Band Management

You can configure in-band management in order to manage the unit remotely via its radio and/or Ethernet
interfaces.
Each PTP 820G or PTP 820F unit includes a pre-defined management service with Service ID 1025. The
management service is a multipoint service that connects the two local management ports and the network
element host CPU in a single service. In order to enable in-band management, you must add at least one service
point to the management service, in the direction of the remote site or sites from which you want to access the
unit for management. For instructions on adding service points, see
Note
In order to use in-band management, it must be supported on the external switch.
Configuring Service
phn-3965_006v002
Page 2-17
Configuring In-Band Management
Points.