Cambium Networks PTP 820 Series User Manual page 930

Chapter 20: Ethernet Protocols (CLI)
Table 260 G.8032 Switching and Reversion CLI Parameters
Parameter Input Type
erpi-id Number
SP Number or
Variable
The following command initiates a forced switch in the East service point of ERPI 1:
root> ethernet g8032 fs-erpi erpi-id 1 SP east
The following command initiates a manual switch in the Sub-Ring service point of ERPI 20:
root> ethernet g8032 ms-erpi erpi-id 20 SP sub-ring
The following command initiates convergence in the East service point of ERPI 1:
root> ethernet g8032 clear-erpi erpi-id 1 SP east
Blocking or Unblocking R-APS Messages on a Service Point
(CLI)
To enable or disable transmission of R-APS messages on a service point, enter the following command in root view:
root> ethernet g8032 set-erpi-sp-tx-raps-cntrl erpi-id <erpi-id> SP <SP>
tx-raps <tx-raps>
Table 261 G.8032 Switching and Reversion CLI Parameters
Parameter Input Type
erpi-id Number
SP Variable
tx-raps Variable
Permitted Values Description
The ID of the ERPI on which you want to
1-64
perform or clear the switch or initiate
convergence.
east Specifies the service point on which to clear
west the manual or forced switch or to
sub-ring implement convergence.
Permitted Values Description
1-64 The ID of the ERPI on which you want to
perform or clear the switch or initiate
convergence.
east Specifies the service point on which to clear
west the manual or forced switch or to
sub-ring implement convergence.
true
true
on the service point.
false
false
blocked on the service point.
phn-3965_006v002
Page 20-7
– R-APS message transmission is enabled
– R-APS message transmission is
Configuring G.8032 (CLI)