Chapter 5: Radio Configuration
5.
In the Excessive BER Threshold field, select the level above which an excessive BER alarm is issued for errors
detected over the radio link.
6. In the Signal Degrade BER Threshold field, select the level above which a Signal Degrade alarm is issued for
errors detected over the radio link.
7. Click Apply, then Close.
Displaying MRMC Status
Related Topics:
•
Entering Radio View (CLI)
•
To view
and configure radio parameters, you must first enter the radio's view level in the CLI.
Use the following command to enter a radio's view level:
root> radio slot <slot> port <port>
The following command enters radio view for fixed radio interface 1:
root> radio slot 1 port 1
The following prompt appears:
radio[1/1]>
The following command enters radio view for fixed radio interface 2:
root> radio slot 1 port 2
The following prompt appears:
radio[1/2]>
The following command enters radio view for an RMC in expansion slot 3:
Configuring and Viewing Radio PMs and Statistics
phn-3965_006v002
Page 5-30