Cambium Networks PTP 820 Series User Manual page 813

Chapter 17: Radio Configuration (CLI)
radio [1/1]>rf pm-rsl-tsl show interval 15min
RF PM table:
==========================================================================
Interval Integrity Min RSL (dBm) Max RSL (dBm) Min TSL (dBm) Max TSL (dBm) TSL exceed RSL exceed RSL exceed
threshold threshold1 threshold2
seconds seconds seconds
==========================================================================
radio [1/1]>
Table 168 RSL and TSL PMs (CLI)
Parameter Description
Interval The number of the interval: 1-30 for daily PM reports, and 1-96 for 15 minute
PM reports.
Integrity Indicates whether the values received at the time and date of the measured
interval are reliable. "1" in the column indicates that the values are not
reliable due to a possible power surge or power failure that occurred at that
time.
Min RSL (dBm) The minimum RSL (Received Signal Level) that was measured during the
interval.
Max RSL (dBm) The maximum RSL (Received Signal Level) that was measured during the
interval.
Min TSL (dBm) The minimum TSL (Transmit Signal Level) that was measured during the
interval.
Max TSL (dBm) The maximum TSL (Transmit Signal Level) that was measured during the
interval.
TSL exceed The number of seconds the measured TSL exceeded the threshold during the
threshold seconds interval. See
RSL exceed The number of seconds the measured RSL exceeded RSL threshold 1 during
threshold1 the interval. See
seconds
RSL exceed The number of seconds the measured RSL exceeded RSL threshold 2 during
threshold2 the interval. See
seconds
Configuring the Signal Level Threshold (CLI)
To set the BER (Bit Error Rate) level above which a Signal Degrade alarm is issued for errors detected over the radio
link, go to radio view and enter the following command:
Configuring TSL Thresholds
Configuring RSL Thresholds (CLI)
Configuring RSL Thresholds (CLI)
phn-3965_006v002
Page 17-24
Configuring and Viewing Radio PMs and Statistics (CLI)
(CLI).