Chapter 9: TDM Services and Interfaces
Displaying Native TDM Service PMs
To display PMs for all Native TDM services defined in the system:
1
Select TDM > PM & Statistics > Service. The Services PM page opens.
Figure 340 Services PM Page (Native TDM Services)
2
In the Service field, select a service.
3
In the Interval Type field, select:
o
To display reports in 15-minute intervals, select 15 minutes.
o
To display reports in daily intervals, select 24 hours.
Table 112
describes the Native TDM Service PMs.
Table 112 Native TDM Service PMs
Parameter
ES
SES
UAS
FC
Integrity
To display the PMs in a graph format, click Graph.
Definition
Indicates the number of seconds during which errors occurred.
Indicates the number of seconds during which severe errors occurred.
Indicates the Unavailable Seconds value of the current interval. The value
can be between 0 and 900 seconds (15 minutes).
Indicates the number of LOPS (Loss of Packets) events during the current
interval.
Indicates whether the values received at time and date of the measured
interval are reliable. An x in the column indicates that the values are not
reliable due to a possible power surge or power failure that occurred at
that time.
phn-3965_006v002
Page 9-73
Displaying TDM PMs