Cambium Networks PTP 820 Series User Manual page 892

Chapter 19: Quality of Service (QoS) (CLI)
Parameter Input Type
sp-id Number
mode Variable
The following command enables marking mode on Service Point 3 on Service 2:
service[2]>sp marking set spid 3 mode enable
The following command disables marking mode on Service Point 3 on Service 2:
service[2]>sp marking set spid 3 mode disable
Marking Table for C-VLAN UP Bits (CLI)
When marking is performed, the following table is used by the marker to decide which CoS and Color to use as the
egress CoS and Color bits for C-VLAN-tagged frames.
Table 235 Marking Table for C-VLAN UP Bits
Permitted Values Description
1-32 for P2P and MP The Service Point ID.
services.
1-30 for MNG
services.
enable Determines whether re-marking of the
disable outer VLAN (C-VLAN or S-VLAN) of tagged
frames that pass through the service point
is enabled.
If mode
preservation for the relevant outer VLAN
is set to
marks the C-VLAN or S-VLAN 802.1p UP
bits of egress frames according to the
calculated CoS and Color, and the user-
configurable 802.1Q and 802.1AD marking
tables.
If mode
preservation for the relevant outer VLAN
is also set to
performed.
If
mode
preservation for the relevant outer VLAN
is also set to
applied, but only according to the values
defined for Green frames in the 802.1Q
and 802.1AD marking tables.
For information about configuring CoS
Preservation, refer to CoS Preservation
and Modification on a Service Point.
phn-3965_006v002
Page 19-25
Configuring Marking (CLI)
is set to enable , and CoS
, the service point re-
disable
is set to enable and CoS
enable , re-marking is not
is set to and CoS
disable
, re-marking is
disable