Cambium Networks PTP 820 Series User Manual page 327

Chapter 5: Radio Configuration
radio[1/1]>remote-unit mute set admin off
Displaying the Remote Radio's RX Level (CLI)
To display the remote radio's RX level, enter the following command in radio view:
radio[x/x]>remote-unit show rx-level
Configuring the Remote Radio's TX Level (CLI)
To set the transmit (TX) level of the remote radio, enter the following command in radio view:
radio[x/x]>remote-unit set tx-level <tx-level>
To display the transmit (TX) level of the remote radio, enter the following command in radio view:
radio[x/x]>remote-unit show tx-level
Paramet
er
tx-level
The following command sets the TX level of the remote radio connected to fixed radio interface 1 to 10 dBm:
radio[1/1]>remote-unit set tx-level 10
Configuring Remote ATPC (CLI)
To set the RX reference level for ATPC on the remote radio, enter the following command in radio view:
radio[x/x]>remote-unit atpc set ref-level <ref-level>
To display the RX reference level for ATPC on the remote radio, enter the following command in radio view:
radio[x/x]>remote-unit atpc show ref-level
Paramet
er
ref-level
Table 47: Remote Radio TX Level CLI Parameters
Input Permitted Values
Type
Numb Depends on the frequency
er and RFU type.
Table 48: Remote Radio ATPC CLI Parameters
Input Permitte
Type d Values
Numb -70 - -30
er
phn-3965_006v002
Page 5-13
Configuring the Remote Radio Parameters
Description
The desired TX signal level
(TSL), in dBm.
Description
The RX reference level for the ATPC
mechanism.