Chapter 12: Alarm Management and Troubleshooting
4.
Click Apply, then Close.
Once you have added local and remote MEPs, you must define the MEPs and determine which are the local MEPs:
1.
Select Ethernet > Protocols > SOAM > MEP. The SOAM MEP page opens.
parameters displayed in the SOAM MEP page.
Figure 417 SOAM MEP Page
Note
To display MEPs belonging to a specific MEG, select the MEG in the Filter by MA/MEG field near the
top of the SOAM MEP page. To display all MEPs configured for the unit, select All.
2.
Click Add. Page 1 of the Add SOAM MEP wizard opens.
Figure 418 Add SOAM MEP Wizard – Page 1
3.
In the MEG Name field, select an MA/MEG.
4.
Click Next. Page 2 of the Add SOAM MEP wizard opens.
e. Configuring the Local MEPs
phn-3965_006v002
Page 12-32
Performing Diagnostics
Table 125
lists and describes the