Adding An Ethernet Service - Cambium Networks PTP 820C User Manual

Chapter 6: Ethernet Services and Interfaces
Table 28 Ethernet Services Page Parameters
Parameter
Services ID
Service Type
Service sub type
EVC ID
EVC description
Admin

Adding an Ethernet Service

To add an Ethernet service:
1. Select Ethernet > Services. The Ethernet Services page opens
2. In the Ethernet Services page, click Add. The Ethernet Services – Add page opens.
Definition
A unique ID for the service.
The service type:

MP – Multipoint

P2P – Point-to-Point

MNG – Management
Indicates the type of service (Ethernet).
The Ethernet Virtual Connection (EVC) ID. This parameter does
not affect the network element's behavior, but is used by the
NMS for topology management.
The Ethernet Virtual Connection (EVC) description. This
parameter does not affect the network element's behavior, but
is used by the NMS for topology management.
Indicates whether the service is enabled (Operational) or
disabled (Reserved). You can configure services for later use by
defining the service as Reserved. In Reserved mode, the service
occupies system resources but is unable to transmit and
receive data.
phn-3963_004v000
Page 6-4
Configuring Ethernet Service(s)
(Figure 117).