Cambium Networks PTP 820 Series User Manual page 680

Chapter 12: Alarm Management and Troubleshooting
Parameter
MIP Creation
Table 124 SOAM MA/MEG Status Parameters
Parameter
MA/MEG ID
MA/MEG Name Format
Tx Sender ID TLV content
Port Status TLV TX
Interface Status TLV TX
MEP List
Configuring MEPs
Each MEP is attached to a service point in an Ethernet service. The service and service point must be configured
before you configure the MEP. See
Each MEP inherits the same VLAN, C-VLAN, or S-VLAN configuration as the service point on which it resides. See
Configuring Service Points.
In order to set the VLAN used by CCM/LBM/LTM if the service point is defined ambiguously (for example PIPE,
Bundle-C, Bundle-S, or All-to-One), the service point's C-VLAN/S-VLAN parameter should not be set to N.A.
To configure a MEP, you must:
1. Add MEPs to the relevant MA/MEG. In this stage, you add both local and remote MEPs. The only thing you
define at this point is the MEP ID. See
2. Configure the local MEPs. At this point, you determine which MEPs are local MEPs. The system
automatically defines the other MEPs you configured in the previous step as remote MEPs. See
the Local MEPs.
3. Enable the Local MEPs. See
Definition
Determines whether MIPs are created on the MEG. Options are:
•
MHF none – No MIPs are created.
•
MHF default – MIPs are created automatically on any service point in
the MEG's Ethernet service.
•
MHF explicit – MIPs are created on the service points of the MEG
when a lower-level MEP exists on the service point. This option is
usually used when the operator's domain is encompassed by another
domain.
•
MHF defer – No MIPs are created. Not used in the current release.
Definition
Automatically generated by the system.
Reserved for future use. In the current release, this is Char String only.
Sender ID TLV is transmitted.
Reserved for future use. No Port Status TLV is transmitted in the CCM
frame.
An Interface Status TLV is transmitted in the CCM frame, indicating the
operational status of the interface on which the transmitting MEP is
configured (Up or Down)..
Lists all local and remote MEPs that have been defined for the MEG.
Configuring Ethernet Service(s).
Adding Local and Remote
Enabling Local MEPs.
phn-3965_006v002
Page 12-30
Performing Diagnostics
MEPs.
Configuring