Chapter 15: Configuration Guide (CLI)
Configuring HSB Radio Protection (CLI)
Note
This section is only relevant for PTP 820G.
This section includes:
•
HSB Radio Protection Overview (CLI)
•
Configuring 1+1 HSB without Space Diversity (CLI)
•
Configuring 1+1 HSB with Space Diversity (CLI)
•
Copying Configuration to Mate (CLI)
•
Revertive Mode (CLI)
•
Switchovers and Lockout (CLI)
•
Deleting an HSB Radio Protection Group (CLI) without Space Diversity
•
Deleting an HSB Radio Protection Group with Space Diversity (CLI)
HSB Radio Protection Overview (CLI)
In dual-carrier systems, PTP 820G offers 1+1 HSB radio protection. With Multi-Carrier ABC, you can also configure
1+1 HSB radio protection with BBS Space Diversity.
You can configure the two radio interfaces as a protection group, which protects against hardware failure in the
RFU. The CPU monitors the radio interfaces and initiates switchover upon indication of a hardware or signal failure.
The radios in a protected pair operate in active and standby mode. If there is a failure in the active radio, the
standby radio switches to active mode.
Configuring 1+1 HSB without Space Diversity (CLI)
To create a 1+1 HSB radio protection group without Space Diversity, Multi-Carrier ABC may not be configured on
the unit.
To create a protection group:
1
Enter the following command in root view. Radio interface 1 will automatically be the active radio carrier.
root>radio protection create group <group> radio <radio> port <port>
radio <radio> port <port> type 1-plus-1-HSB
Table 145 1+1 HSB CLI Parameters
Parameter
Input Type
group
Number
radio
Number
Permitted Values
Description
1-4
The group ID of the protection group.
1
phn-3965_006v002
Page 15-23
Configuring HSB Radio Protection (CLI)