Cambium Networks PTP 820 Series User Manual page 974

Chapter 21: TDM Services and Interfaces (CLI)
Table 281 Pseudowire Profile CLI Parameters
Parameter Input Type
id Number
payload-size Number
jitter-buffer- Number
depth
payload- Variable
suppression
The following commands add TDM profile 5, with a payload size of 2, jitter buffer depth of 4 milliseconds, and
payload suppression disabled:
pwe3> pwe3 pw-profile add id 5
pwe3> pwe3 pw-profile basic-params modify id 5 payload-size 2 jitter-
buffer-depth 4 payload-suppression disable
To verify the details of the profile you just created, enter the following command:
pwe3> pwe3 pw-profile show id 5
Configuring Ethernet Services for TDM Traffic (CLI)
You can configure traffic services for TDM traffic using the same commands and parameters used for Ethernet
services. For instructions, refer to
The following commands add a multipoint service with an EVC ID of PW-Slot12_EVC-70. This service has the
following service points:
•
A service point on a 1+1 HSB group (rp3), with an s-tag interface type and VLAN 4070 classified to the service
point.
•
A service point on the E1/DS1 interface, port 1, with a dot1q interface type and VLAN 4070 classified to the
service point.
Permitted Values
1-64
1-64
1-32
enable
disable
Ethernet Services Overview
phn-3965_006v002
Page 21-13
Configuring TDM Pseudowire Services (CLI)
Description
A unique ID that identifies the profile.
The number of times E1 should be
sampled for each Ethernet packet.
The desired jitter buffer depth (in
milliseconds). This is used to enable the
network to accommodate PSN-specific
packet delay variation. The jitter buffer
can be increased if the network
experiences a higher-than-normal level
of jitter.
Enables or disables payload suppression.
When enabled, the payload is
suppressed upon incoming TDM failure.
(CLI).