Cambium Networks PTP 820 Series User Manual page 964

Chapter 21: TDM Services and Interfaces (CLI)
Configuring the Unit to Operate in ANSI Mode (CLI)
By default, the TDM interfaces in a PTP 820G or PTP 820F unit are set to operate according to the ETSI standard, in
E1 mode.
To change the TDM interfaces to operate according to the ANSI (FCC) standard (DS1), enter the following
command in root view.
Note
This command results in system reset and restores the default configuration.
root> platform management set tdm-interfaces-standard ansi
Configuring the Unit to Operate in ANSI Mode (CLI)
phn-3965_006v002
Page 21-3