Cambium Networks PTP 820 Series User Manual page 928

Chapter 20: Ethernet Protocols (CLI)
Parameter Input Type
erpi-id Number
SP Number or
Variable
The following command sets the East service point as the RPL owner for ERPI 1:
root> ethernet g8032 set-rpl-owner erpi-id 1 SP east
The following command sets the Sub-Ring service point as the RPL owner for ERPI 20:
root> ethernet g8032 set-rpl-owner erpi-id 20 SP sub-ring
The following command removes the RPL owner for ERPI 1:
root> ethernet g8032 remove-rpl-owner erpi-id 1
Configuring Timers (CLI)
You can configure timers per ERPI to control the ERPI's switching and convergence parameters. The following
timers are available:
•
Wait to Restore (WTR) Timer – Defines a minimum time the system waits after signal failure is recovered
before reverting to idle state.
•
Guard Time – Prevents unnecessary state changes and loops.
•
Hold-Off Time – Determines the time period from failure detection to response.
To configure the WTR timer, enter the following command in root view:
root> ethernet g8032 set-wtr erpi-id <erpi-id> wtr <wtr>
To configure the guard time, enter the following command in root view:
root> ethernet g8032 set-guard-time erpi-id <erpi-id> guard-time <guard-
time>
To configure the hold-off, enter the following command in root view:
root> ethernet g8032 set-holdoff-time erpi-id <erpi-id> holdoff-time
<holdoff-time>
Table 259 G.8032 Timer Configuration CLI Parameters
Parameter Input Type
erpi-id Number
wtr Number
Permitted Values Description
1-64 The ID of the ERPI for which you want to set
or delete the RPL owner.
east Specifies the service point you want to
west designate as the RPL owner.
sub-ring
Permitted Values Description
1-64 The ID of the ERPI for which you want to set
a timer.
1-12 The minimum time (in minutes) the system
waits after signal failure is recovered before
reverting to idle state.
phn-3965_006v002
Page 20-5
Configuring G.8032 (CLI)