Cambium Networks PTP 820 Series User Manual page 929

Chapter 20: Ethernet Protocols (CLI)
Parameter Input Type
guard-time Number
holdoff-time Number
The following command sets the WTR timer for ERPI 1 to 2 minutes:
root> ethernet g8032 set-wtr erpi-id 1 wtr 2
The following command sets the guard time for ERPI 1 to 20 msecs:
root> ethernet g8032 set-guard-time erpi-id 1 guard-time 20
The following command sets the hold-off time for ERPI 1 to 1000 msecs:
root> ethernet g8032 set-holdoff-time erpi-id 1 holdoff-time 1000
Initiating a Manual or Forced Switch and Clearing the Switch
or Initiating Reversion (CLI)
To initiate a forced switch, enter the following command in root view:
root> ethernet g8032 fs-erpi erpi-id <erpi-id> SP <SP>
To initiate a manual switch, enter the following command in root view:
root> ethernet g8032 ms-erpi erpi-id <erpi-id> SP <SP>
You can use a "clear" command to clear a forced or manual switch. You can also use a "clear" command to trigger
convergence prior to the expiration of the relevant timer. To issue a "clear" command, enter the following
command in root view:
root> ethernet g8032 clear-erpi erpi-id <erpi-id> SP <SP>
Permitted Values Description
10-2000, in The minimum time (in msec) the system
multiples of 10 waits after recovery from a signal failure
before accepting new R-APS messages. The
purpose of this timer is to prevent
unnecessary state changes and loops.
0-10000, in The minimum time (in msec) the system
multiples of 100 waits before reacting to a signal failure.
phn-3965_006v002
Page 20-6
Configuring G.8032 (CLI)