Cambium Networks PTP 820 Series User Manual page 859

Chapter 18: Ethernet Services and Interfaces (CLI)
Configuring Automatic State Propagation and Link
Loss Forwarding (CLI)
Automatic state propagation enables propagation of radio failures back to the Ethernet port. You can also
configure Automatic State Propagation to close the Ethernet port based on a radio failure at the remote carrier.
Automatic state propagation is configured as pairs of interfaces. Each interface pair includes a Monitored Interface
and a Controlled Interface. The Monitored Interface is a radio or TDM interface, or a radio protection or Multi-
Carrier ABC group. The Controlled Interface is an Ethernet interface LAG. Only one ASP pair can be configured per
radio or TDM interface or radio protection or Multi-Carrier ABC group, and only one ASP pair can be configured per
Ethernet interface.
Note
It is recommended to configure both ends of the link to the same Automatic State Propagation
configuration.
Configuring Automatic State Propagation to an Ethernet Port
(CLI)
To configure propagation of a radio interface failure to an Ethernet port, use the following commands:
root> auto-state-propagation add eth-port-to-radio eth-slot <eth-slot>
eth-port <eth-port> radio-slot <radio-slot> radio-port <radio-port>
To enable automatic state propagation on an Ethernet port and determine whether remote interface failures are
also propagated, use the following command:
root> auto-state-propagation configure eth-port eth-slot <eth-slot> eth-
port <eth-port> asp-admin <asp-admin> remote-fault-trigger-admin <remote-
fault-trigger-admin> csf-mode-admin <csf-mode-admin>
To delete automatic state propagation on an Ethernet port, use the following command:
root> auto-state-propagation delete eth-port eth-slot <eth-slot> eth-port
<eth-port>
To display all automatic state propagation configurations on the unit, use the following command:
root> auto-state-propagation show-config all
To display the automatic state propagation configuration for a specific Ethernet port, use the following command:
root> auto-state-propagation show-config eth-port eth-slot <eth-slot>
eth-port <eth-port>
Configuring Automatic State Propagation and Link Loss
phn-3965_006v002
Page 18-40
Forwarding (CLI)