Cambium Networks PTP 820 Series User Manual page 903

Chapter 19: Quality of Service (QoS) (CLI)
eth type eth [1/1]> queue-shaper edit service-bundle-id 1 cos 0 admin-
state enable profile-id 2
Configuring Service Bundle Shapers (CLI)
You can configure up to 256 dual leaky bucket service bundle shaper profiles. The profiles can be configured as
follows:
Valid CIR values are:
•
0 – 32,000,000 bps, with granularity of 16,000 bps
•
32,000,000 – 1,000,000,000 bps, with granularity of 64,000 bps
Valid PIR values are:
•
16,000 – 32,000,000 bps, with granularity of 16,000 bps
•
32,000,000 – 1,000,000,000 bps, with granularity of 64,000 bps
Note
You can enter any value within the permitted range. Based on the value you enter, the software
automatically rounds off the setting according to the granularity. If you enter a value below the
lowest granular value (except 0), the software adjusts the setting to the minimum.
You can attach one of the configured service bundle shaper profiles to each service bundle. If no profile is attached
to the service bundle, no egress shaping is performed on that service bundle.
This section includes:
•
Configuring Service Bundle Shaper Profiles (CLI)
•
Attaching a Shaper Profile to a Service Bundle (CLI)
phn-3965_006v002
Page 19-36
Configuring Shapers (CLI)