Chapter 6: Ethernet Services and Interfaces
Table 29 Ethernet Services Page Parameters
Parameter
Services ID
Service Type
Service sub type
EVC ID
EVC description
Admin
Adding an Ethernet Service
To add an Ethernet service:
1. Select Ethernet > Services. The Ethernet Services page opens
2. In the Ethernet Services page, click Add. The Ethernet Services – Add page opens.
Definition
A unique ID for the service.
The service type:
•
MP – Multipoint
P2P – Point-to-Point
•
•
MNG – Management
Note: In release 10.6, only P2P and MNG services are supported. In
release 10.9, MP services are also supported.
Indicates the type of service (Ethernet).
The Ethernet Virtual Connection (EVC) ID. This parameter does not affect
the network element's behavior, but is used by the NMS for topology
management.
The Ethernet Virtual Connection (EVC) description. This parameter does
not affect the network element's behavior, but is used by the NMS for
topology management.
Indicates whether the service is enabled (Operational) or disabled
(Reserved). You can configure services for later use by defining the
service as Reserved. In Reserved mode, the service occupies system
resources but is unable to transmit and receive data.
phn-3963_008v000
Page 6-4
Configuring Ethernet Service(s)
(Figure
93).