Chapter 20: Ethernet Protocols (CLI)
o
4 - router
o
5 - telephone
o
6 - docsisCableDevice
o
7 - stationOnly
o
8 - cVLANComponent
o
9 - sVLANComponent
o
10 - twoPortMACRelay
•
Rem System Cap Enabled
peer. The bitmap is defined by the following parameters:
o
0 - other
o
1 - repeater
o
2 - bridge
o
3 - wlanAccessPoint
o
4 - router
o
5 - telephone
o
6 - docsisCableDevice
o
7 - stationOnly
o
8 - cVLANComponent
o
9 - sVLANComponent
o
10 - twoPortMACRelay
•
- Indicates whether there are changes in the peer's MIB, as determined by the variable
Remote Changes
remoteChanges. Possible values are:
o
- Changes have taken place in the peer's MIB since the defined agent-start-time.
True
o
False
- No changes have taken place in the peer's MIB since the defined agent-start-time.
Displaying the LLDP Remote Management Data per Port (CLI)
To display remote LLDP management data from a specific port, starting from a specific time, enter the following
command in root view. If no time is specified, all data is displayed.
root> ethernet lldp agent-remote-mng-show agent-start-time <agent-start-
time> interface eth slot <slot> port <port>
The following information is displayed:
•
– The time the entry was created.
Time Mark
•
Interface Type/Slot/Port
•
Rem Dest Mac Address
•
Remote Index
– An arbitrary local integer value used by this agent to identify a particular connection
instance, unique only for the indicated peer.
•
Remote Mng Addr subType
LLDP Agent Remote Management Address.
•
Remote Mng Address
with the remote system. The purpose of this address is to contact the management entity.
- The bitmap value used to identify which system capabilities are enabled on the
– The port for which you are displaying data about the peer.
– The peer LLDP agent's destination MAC Address.
– The type of management address identifier encoding used in the associated
– The octet string used to identify the management address component associated
phn-3965_006v002
Page 20-35
Configuring LLDP (CLI)