Cambium Networks PTP 820 Series User Manual page 918

Chapter 19: Quality of Service (QoS) (CLI)
To configure and display queue-level PMs, you must first enter interface view. See Error! Reference source not
found..
To display whether any service bundles are configured on an interface, enter the following command in interface
view:
eth type eth [x/x]> eth type eth [1/2]>pm tm-queue show configuration all
If no service bundles have been configured, the following output is displayed:
eth type eth [x/x]>pm tm-queue show configuration all
Num entries: 0
If a service bundle has been configured and enabled, the following output is displayed:
eth type eth [x/x]>pm tm-queue show configuration all
Service bundle: 1
Num entries: 1
If a service bundle has been configured but it's Admin status is disabled, the following output is displayed:
eth type eth [x/x]>pm tm-queue show configuration all
Service bundle: 1
Num entries: 1
To configure a service bundle, enter the following command in interface view:
eth type eth [x/x]> pm tm-queue create service-bundle-id <1-6> admin-state
<enable|disable>
To change the Admin state of a service bundle, enter the following command in interface view:
eth type eth [x/x]> pm tm-queue set service-bundle-id <1-6> admin-state
<enable|disable>
To remove a service bundle, enter the following command in interface view:
eth type eth [x/x]> pm tm-queue remove service-bundle-id <1-6>
For example:
eth type eth [1/1]>pm tm-queue remove service-bundle-id 1
WARNING: All PM history for that service bundle will be deleted.
Are you sure? (yes/no):yes
eth type eth [1/1]>
To display the threshold settings for a service bundle, enter the following command in interface view:
eth type eth [x/x]> pm tm-queue show configuration service-bundle-id <1-6>
Admin: enable
Admin: disable
phn-3965_006v002
Page 19-51
Displaying Egress Statistics (CLI)