Cambium Networks PTP 820 Series User Manual page 737

Chapter 15: Configuration Guide (CLI)
Note
Radio slot 2 port 1 should always be configured on channel 1 while Radio slot 2 port 2 should always
be configured on channel 2.
Configuring Multi-Carrier ABC for PTP 820F (CLI)
To configure a Multi-Carrier ABC group for PTP 820F (CLI):
1. Create the group by entering the following command in root view.
root> multi-carrier-abc create group group_id 1 slot 1 type RFU
2. Add members to the group by entering the following commands to enter Multi-Carrier ABC Group view and
attaching both carriers of the RFU (ports) to the group.
root> multi-carrier-abc group-id <1-4> slot <slot> type RFU
multi-carrier-abc group-id 1 slot 1
multi-carrier-abc group-id [x]> attach-member slot 1 port 1 channel-id <1-16>
multi-carrier-abc group-id [x]> attach-member slot 1 port 2 channel-id <1-16>
The Channel ID identifies the interface within the group.
3. To set the amount of bandwidth in the Multi-Carrier ABC group, in kbps, reserved for Ethernet traffic, enter
the following command in Multi-Carrier ABC Group view:
multi-carrier-abc group-id 1 slot 1 high-pri-ethernet-bandwidth set <1-
2147483647>
Note
If you are managing the unit using in-band management, it is strongly recommended to set this
parameter to a value that will ensure that sufficient Ethernet bandwidth is available at all times for
management traffic. The default value is 0..
The following commands create a Multi-Carrier ABC group with the two carriers of an RFU-D or RFU-D-HP, and
assign 100000 kbps to Ethernet traffic.
root> multi-carrier-abc create group group_id 1 slot 1 type RFU
root> multi-carrier-abc group-id 1 slot 1 type RFU
multi-carrier-abc group-id [1] slot [1]>attach-member slot 1 port 1
channel-id 1
multi-carrier-abc group-id [1] slot [1]>attach-member slot 1 port 2
channel-id 2
multi-carrier-abc group-id [1] slot [1]>
multi-carrier-abc group-id [1] slot [1]> high-pri-ethernet-bandwidth set
100000
multi-carrier-abc group-id [1] slot [1]> exit
phn-3965_006v002
Page 15-6
Configuring Multi-Carrier ABC (CLI)