Cambium Networks PTP 820 Series User Manual page 968

Chapter 21: TDM Services and Interfaces (CLI)
Parameter Input Type
clk-src-ref- Number
port
idle-code Number
cable-length Variable
The following commands configure and enable port 9 in the E1/DS1 interface.
pwe3> pwe3 tdm config modify port slot 1 tdm-port 9 line-type unframed
line-coding hdb3-b8zs channelization disable timing-mode loop clk-src-ref
none clk-src-ref-port 9 idle-code 0 cable-length fixed-or-0-133ft
pwe3> pwe3 tdm enable slot 1 tdm-port 9
To verify the configuration of the TDM port you use configured, enter the following command:
pwe3> pwe3 tdm config show slot 1 tdm-port 9
Permitted Values Description
0-16 The recovery clock source reference port. If
timing-mode
recovery
the port.
By default, each port is its will take itself as a
reference. Select a different port only if more
than 16 clock domains are being used.
If
parameter must be set to 0.
0-255 The value to be transmitted on this port for
unused time slots.
ffixed-or-0-133ft Reserved for future use.
133-266ft/266-399ft
399-533ft
533-655ft
phn-3965_006v002
Page 21-7
Configuring TDM Cards and Interfaces (CLI)
is set to loop
, select the clock source reference for
is set to
timing-mode absolute
or clock-
, this