Cambium Networks PTP 820 Series User Manual page 684

Chapter 12: Alarm Management and Troubleshooting
Table 125 SOAM MEP Parameters
Parameter
MD (ID, Name)
MA/MEG (ID, Name)
MEP ID
Interface Location
SP ID
MEP Direction
MEP Fault Notification
State
Connectivity Status
MEP Active
MEP CCM TX Enable
CCM and LTM Priority
MEP Defects
RMEP List
Once you have added a MEP and defined it as a local MEP, you must enable the MEP.
To enable a MEP:
1. In the SOAM MEP page
Definition
The MD ID and name are automatically generated by the system.
The MA/MEG ID and name are automatically generated by the system.
The MEP ID.
The interface on which the service point associated with the MEP is
located.
The service point ID.
Up or Down.
Indicates the status of the defect SOAM state machine. Possible values
are:
•
Fng Reset – Initial state.
•
Fng Defect – Transient state when a defect is detected.
•
Fng Defect Reported – The defect state is steady (stable).
•
Fng Defect Clearing – Transient state when a defect is in the process
of being cleared.
•
Fng Defect Cleared – The defect has been cleared (transient state).
Indicates whether a MEP can exchange PDU (CCM, Loopback, LTR) with its
remote MEP. A MEP with some defect or an inactive MEP cannot
exchange PDUs.
Possible values are:
•
inactive – At least one of the remote MEPs is in rMEPFailed status
(not discovered).
•
active – All remote MEPs are discovered correctly and have an
rMEPOk status.
Indicates whether the MEP is enabled (True) or disabled (False).
Indicates whether the MEP is sending CCMs (True/False).
The p-bit included in CCMs and/or LTM frames sent by this MEP (0 to 7).
Indicates if a defect has been detected by the MEP level.
Once you have configured at least one local MEP, all other MEPs that you
have added but not configured as local MEPs are displayed here and are
considered to be remote MEPs.
f. Enabling Local MEPs
(Figure 417), select the MEP you want to enable.
phn-3965_006v002
Page 12-34
Performing Diagnostics