Cambium Networks PTP 820 Series User Manual page 203

Chapter 3: Configuration Guide
Note
For a full explanation of Ethernet Services, service types, and attached interface types, see
Configuring Ethernet
5 Click Next. Page 2 of the 1+1 Multi Carrier ABC HSB-SD Quick Configuration wizard opens.
Figure 71 1+1 Multi Carrier ABC HSB-SD Quick Configuration Wizard – Page 2
6 In the Radio #2 Interface field, select the Standby radio interface for the link. Alternatively, click the
interface in the graphical representation of the unit. The selected interface is surrounded by an orange
circle, as shown in Figure
7 In the Revertive Mode field, select Yes or No to determine whether or not the HSB radio protection group
will operate in revertive mode. When revertive mode is enabled, following a switchover the system initiates
a revertive protection switchover back to the original receiver ten minutes after proper link and/or
equipment conditions are restored. This ensures that the primary path is used whenever possible.
8 Click Next. Page 3 of the 1+1 Multi Carrier ABC HSB-SD Quick Configuration wizard opens.
Figure 72 1+1 Multi Carrier ABC HSB-SD Quick Configuration Wizard – Page 3
9 In the TX Frequency (MHz) field, set the transmission radio frequency in MHz.
10 In the RX Frequency (MHz) field, set the received radio frequency in MHz.
Service(s).
71. This interface will be the Standby radio in the protection group.
phn-3965_006v002
Page 3-45
Configuring a Link Using the Quick Configuration Wizard