Cambium Networks PTP 820 Series User Manual page 723

Chapter 14: Getting Started (CLI)
Configuring the Transmit (TX) Frequency (CLI)
To set the transmit (TX) frequency of a radio, enter the following command in radio view. This command
automatically sets the remote RX frequency in parallel, unless you set the
radio[x/x]>rf set tx-frequency <tx-frequency> local-remote <local-remote>
Table 135 Radio Transmit (TX) Frequency CLI Parameters
Parameter Input Type
tx-frequency Number
local-remote Variable
The following command sets the TX frequency of radio interface 1 to 12900000 KHz, and sets the RX frequency of
the remote unit to the same value.
radio[1/1]>rf set tx-frequency 12900000
The following command sets the TX frequency of radio interface 2 to 12900000 KHz, but does not set the RX
frequency of the remote unit.
radio[1/2]>rf set rx-frequency 12900000 local-remote disable
Permitted Values
Depends on the MRMC
script and the unit type.
enable
disable
phn-3965_006v002
Page 14-28
Configuring the Transmit (TX) Frequency (CLI)
local-remote attribute to
Description
The desired TX frequency (in KHz) and, if <local-
remote> is set to enable, the desired RX
frequency of the remote unit.
Optional. Determines whether to apply the
configured TX frequency value to the RX
frequency of the remote unit.
disable :