Cambium Networks PTP 820 Series User Manual page 296

Chapter 4: Unit Management
10. If the IP address family is configured to be IPv4, enter the IPv4 address of the PC or laptop you are using as
the FTP/SFTP server in the Server IPV4 address field. See
Communications.
11. If the IP address family is configured to be IPv6, enter the IPv6 address of the PC or laptop you are using as
the FTP/SFTP server in the Server IPv6 Address field. See
Communications.
12. In the Path field, enter the directory path from which you are downloading the files. Enter the path relative to
the FTP user's home directory, not the absolute path. If the location is the home directory, it should be left
empty. If the location is a sub-folder under the home directory, specify the folder name. If the shared folder is
"C:\", this parameter can be left empty or populated with "//.
13. Click Apply to save your settings, then Close to close the FTP Parameters page.
Figure 142 Install Parameters Page
14. Click Download. The download begins. You can view the status of the download in the Download Status
field. See Table 39 Download & Install Status
15. Once the download has been completed, verify that the version you want to install has been downloaded.
You can check the downloaded version for each component by viewing the Downloaded Version column in
the Versions page. See
Caution
If upgrading from version 7.9 or earlier:
Before you proceed to install the software, repeat the download process even if Download Success
is displayed in the Download status field, until the unit displays the message No new software
modules found.
Parameters.
Viewing Current Software Versions.
phn-3965_006v002
Page 4-21
Defining the IP Protocol Version for Initiating
Defining the IP Protocol Version for Initiating
Upgrading the Software