Cambium Networks PTP 820 Series User Manual page 864

Chapter 18: Ethernet Services and Interfaces (CLI)
eth type eth [x/x]> pm show rx-bcast-packets interval 15min
To display RX broadcast packet PMs in 24-hour intervals, go to interface view for the interface and enter the
following command:
eth type eth [x/x]> pm show rx-bcast-packets interval 24hr
To display RX multicast packet PMs in 15-minute intervals, go to interface view for the interface and enter the
following command:
eth type eth [x/x]> pm show rx-mcast-packets interval 15min
To display RX multicast packet PMs in 24-hour intervals, go to interface view for the interface and enter the
following command:
eth type eth [x/x]> pm show rx-mcast-packets interval 24hr
To display Layer 1 RX PMs, in bytes per second, in 15-minute intervals, go to interface view for the interface and
enter the following command:
eth type eth [x/x]> pm show rx-bytes-layer1 interval 15min
To display Layer 1 RX PMs, in bytes per second, in 24-hour intervals, go to interface view for the interface and
enter the following command:
eth type eth [x/x]> pm show rx-bytes-layer1 interval 24hr
To display Layer 2 RX PMs, in bytes per second, in 15-minute intervals, go to interface view for the interface and
enter the following command:
eth type eth [x/x]> pm show rx-bytes-layer2 interval 15min
To display Layer 2 RX PMs, in bytes per second, in 24-hour intervals, go to interface view for the interface and
enter the following command:
eth type eth [x/x]> pm show rx-bytes-layer2 interval 24hr
To display TX packet PMs in 15-minute intervals, go to interface view for the interface and enter the following
command:
eth type eth [x/x]> pm show tx-packets interval 15min
To display TX packet PMs in 24-hour intervals, go to interface view for the interface and enter the following
command:
eth type eth [x/x]> pm show tx-packets interval 24hr
To display TX broadcast packet PMs in 15-minute intervals, go to interface view for the interface and enter the
following command:
eth type eth [x/x]> pm show tx-bcast-packets interval 15min
To display TX broadcast packet PMs in 24-hour intervals, go to interface view for the interface and enter the
following command:
eth type eth [x/x]> pm show tx-bcast-packets interval 24hr
To display TX multicast packet PMs in 15-minute intervals, go to interface view for the interface and enter the
following command:
eth type eth [x/x]> pm show tx-mcast-packets interval 15min
To display TX multicast packet PMs in 24-hour intervals, go to interface view for the interface and enter the
following command:
phn-3965_006v002
Page 18-45
Viewing Ethernet PMs and Statistics (CLI)