Cambium Networks PTP 820 Series User Manual page 766

Chapter 16: Unit Management (CLI)
root> platform security protocols-control snmp admin set enable
root> platform security protocols-control snmp version set v2
root> platform security protocols-control snmpv1v2 set read-community
public write-community private
The following commands enable SNMP v3 on the unit, block SNMP v1 and SNMP v2 access, and define an SNMPv3
user with User Name=Geno, Password=abcdefgh, security mode authPriv, encryption mode DES, authentication
algorithm SHA, and read-write access:
root> platform security protocols-control snmp admin set enable
root> platform security protocols-control snmp version set v3
root> platform security protocols-control snmp v1v2-block set yes
root> platform security protocols-control snmp v3-authentication add v3-
user-name geno v3-user-password abcdefgh v3-security-mode authPriv v3-
encryption-mode DES v3-auth-algorithm SHA v3-access-mode readWrite
Displaying the SNMP Settings (CLI)
To display the general SNMP parameters, enter the following command in root view:
root> platform security protocols-control snmp show-all
To display the current MIB version used in the system, enter the following command in root view:
root> platform security protocols-control snmp show-mib-version
To display details about the current MIB version used in the system, enter the following command in root view:
root> platform security protocols-control snmp show-mib-version-table
To display the SNMP read and write communities, enter the following command in root view:
root> platform security protocols-control snmpv1v2 show
Configuring Trap Managers (CLI)
In this version, trap manager configuration should be performed via the Web EMS. See
phn-3965_006v002
Page 16-8
Configuring SNMP (CLI)
Configuring Trap Managers.