Cambium Networks PTP 820 Series User Manual page 562

Chapter 9: TDM Services and Interfaces
Parameter
Maintenance Association ID
Adding a Tunnel
To add a tunnel:
1 Click Add. The PseudoWire PSN Tunnels – Add page opens.
Figure 329 PseudoWire PSN Tunnels– Add Page
2 In the Tunnel ID field, enter a unique ID, from 1 to 16, to identify the tunnel.
3 In the Tunnel Admin field, select Enable to enable the tunnel, or Disable if you want to add the tunnel but
enable it at a later time.
4 In the Tunnel Type field, select the tunnel's encapsulation type. In this release, only Ethernet Layer 2 MEF-8
encapsulation (Eth) is available.
5 In the Destination MAC Address field, for Ethernet (MEF-8) tunnels, enter the MAC address of the card at
the other site of the link.
6 In the VLAN Type field, select the outer VLAN type used by the tunnel. Options are:
o
None
o
C-type
o
S-type
7 In the VLAN ID field, enter a VLAN ID (1-4090). This value will be assigned to frames passing through the
tunnel.
Definition
Displays the Maintenance Association (MA) ID assigned to the tunnel. This
is only relevant for tunnels that are used in TDM services with path
protection. For more information, see
phn-3965_006v002
Page 9-54
Configuring Advanced Pseudowire Parameters
Configuring a Tunnel Group.