Cambium Networks PTP 820 Series User Manual page 800

Chapter 17: Radio Configuration (CLI)
Table 161 Header De-Duplication CLI Parameters
Parameter Input Type
mode Variable
The following command enables Layer 2 Header De-Duplication on fixed radio interface 1, with a defined flow type
of 0x00:
root> radio slot 1 port 1
radio[1/1]> compression header-compression set mode Layer2
Displaying Header De-Duplication Information (CLI)
To display the current Header De-Duplication configuration, enter the following command in radio view:
radio[x/x]> compression show-configuration
To display counters for Header De-Duplication, enter the following command in radio view:
radio[x/x]> header-compression show-counters
The following counters are displayed:
•
TX in octet count - Bytes on the TX side before Header De-Duplication.
•
TX out octet count - Bytes on the TX side that were compressed by Header De-Duplication.
•
TX frame in count - Frames on the TX side before Header De-Duplication.
Permitted Values
Disabled
Layer2
MPLS
Layer3
Layer4
Tunnel
Tunnel-Layer3
Tunnel-Layer4
phn-3965_006v002
Page 17-11
Configuring Header De-Duplication (CLI)
Description
Disabled - Header De-Duplication is
disabled.
Layer2 - Header De-Duplication
operates on the Ethernet level.
MPLS - Header De-Duplication
operates on the Ethernet and MPLS
levels.
Layer3 - Header De-Duplication
operates on the Ethernet and IP levels.
Layer4 - Header De-Duplication
operates on all supported layers up to
Layer 4.
Tunnel - Header De-Duplication
operates on Layer 2, Layer 3, and on
the Tunnel layer for packets carrying
GTP or GRE frames.
Tunnel-Layer3 - Header De-Duplication
operates on Layer 2, Layer 3, and on
the Tunnel and T-3 layers for packets
carrying GTP or GRE frames.
Tunnel-Layer4 - Header De-Duplication
operates on Layer 2, Layer 3, and on
the Tunnel, T-3, and T-4 layers for
packets carrying GTP or GRE frames.