Chapter 19: Quality of Service (QoS) (CLI)
Displaying Egress Statistics (CLI)
PTP 820G and PTP 820F collects egress PMs at the queue level and the service bundle level.
Displaying Queue-Level PMs (CLI)
PTP 820G and PTP 820F supports the following counters per queue at the queue level:
•
Transmitted Green Packets (64 bits counter)
•
Transmitted Green Bytes (64 bits counter)
•
Transmitted Green Bits per Second (32 bits counter)
•
Dropped Green Packets (64 bits counter)
•
Dropped Green Bytes (64 bits counter)
•
Transmitted Yellow Packets (64 bits counter)
•
Transmitted Yellow Bytes (64 bits counter)
•
Transmitted Yellow Bits per Second (32 bits counter)
•
Dropped Yellow Packets (64 bits counter)
•
Dropped Yellow Bytes (64 bits counter)
To display queue-level PMs, enter interface view for the interface and enter the following command:
eth type eth [x/x]> tm-queue show statistics service-bundle-id <service-
bundle-id> cos <cos> clear-on-read <clear-on-read> layer-1 <layer-1>
To clear queue-level PMs for a specific service bundle, enter interface view for the interface and enter the
following command:
eth type eth [x/x]> tm-queue clear statistics service-bundle-id <service-
bundle-id>
Table 254 Egress Queue Level PMs CLI Parameters
Parameter
Input Type
service-
Number
bundle-id
cos
Number
clear-on-read
Boolean
Permitted
Values
Description
1 – 63
The service bundle for which you want to display
Note: In the
PMs.
current
release, only
Service
Bundle 1 is
supported.
0 - 7
The queue for which you want to display PMs.
yes
If you enter yes, the statistics are cleared once you
no
display them.
phn-3965_006v002
Page 19-49
Displaying Egress Statistics (CLI)