Cambium Networks PTP 820 Series User Manual page 855

Chapter 18: Ethernet Services and Interfaces (CLI)
Viewing Interface Attributes (CLI)
To display an interface's attributes, go to interface view for the interface and enter the following command:
eth type eth [x/x]>summary show
To display an interface's current operational state (up or down), go to interface view for the interface and enter
the following command:
eth type eth [x/x]>operational state show
The following command shows the operational state of GbE 1:
eth type eth [1/1]>operational state show
Configuring an Interface's Media Type (CLI)
The Media Type attribute defines the physical interface Layer 1 media type. Permitted values are RJ-45 and SFP.
Auto Type is only relevant for Ethernet interfaces. When Auto Type is selected, the system detects whether the
optical or electrical port is being used. Auto Type can only be used when the interface speed is set to 1000 Mbps.
To configure an Ethernet interface's Media Type, go to interface view for the interface and enter the following
command:
eth type eth [x/x]>media-type state set <media type>
Table 204 Interface Media Type CLI Parameters
Parameter Input Type
media type Variable
The following command sets Ethernet port 1 to auto-type:
eth type eth [1/1]>media-type state set auto-type
Configuring an Interface's Speed and Duplex State (CLI)
To configure an Ethernet interface's maximum speed and duplex state, go to interface view for the interface and
enter the following command:
eth type eth [x/x]>speed-and-duplex state set <speed-and-duplex state>
Permitted Values Description
auto-type Select the physical interface layer 1 media
rj45 type:
sfp
auto-type
interfaces. The system detects whether
the optical or electrical port is being used.
Auto-type can only be used when the
interface speed is set to 1000 Mbps.
RJ45
interface.
SFP
phn-3965_006v002
Page 18-36
Configuring Ethernet Interfaces (CLI)
– Only relevant for Ethernet
– An electrical (RJ-45) Ethernet
– An optical (SFP) Ethernet interface.