Cambium Networks PTP 820 Series User Manual page 901

Chapter 19: Quality of Service (QoS) (CLI)
root> ethernet qos queue-shaper-profile-tbl add profile-id <profile-id>
cir <cir> shaper-profile-name <shaper-profile-name>
To edit the parameters of an existing queue shaper profile, enter the following command in root view:
root> ethernet qos queue-shaper-profile-tbl edit profile-id <profile-id>
cir <cir> shaper-profile-name <shaper-profile-name> burst-type short
Note
The burst-type parameter is reserved for future use. However, you must enter this parameter in
order for the command to execute.
To display the parameters of a queue shaper profile, enter the following command in root view:
root> ethernet qos queue-shaper-profile-tbl show profile-id <profile-id>
To delete a queue shaper profile, enter the following command in root view:
root> ethernet qos queue-shaper-profile-tbl delete profile-id <profile
id>
You cannot delete a queue shaper profile if it is attached to a queue. You must first remove the profile from the
queue. You can then delete the profile.
Table 241 Queue Shaper Profiles CLI Parameters
Parameter Input Type
profile-id Number
cir Number
shaper-
Text String
profile-name
The following command creates Queue Shaper 1, named "p1", with a CIR value of 16000 bps.
root> ethernet qos queue-shaper-profile-tbl add profile-id 1 cir 16000
shaper-profile-name p1
The following command changes the CIR value of the profile created above from 16000 to 32000, and changes the
profile name to p3.
root> ethernet qos queue-shaper-profile-tbl edit profile-id 1 cir 32000
shaper-profile-name p3 burst-type short
Attaching a Shaper Profile to a Queue (CLI)
You can attach one of the configured queue shaper profiles to each priority queue. If no profile is attached to the
queue, no egress shaping is performed on that queue. Shapers are attached to queues based on the logical
interface and service bundle to which the queue belongs, and the queue's CoS value.
To attach a queue shaper profile to a queue, go to interface view for the interface and enter the following
command:
Permitted Values Description
1 - 32 A unique ID that identifies the profile.
16000 – 131008000 The Committed Information Rate (CIR)
assigned to the profile (in bps).
Up to 20 characters. A description of the profile.
phn-3965_006v002
Page 19-34
Configuring Shapers (CLI)