Cambium Networks PTP 820 Series User Manual page 933

Chapter 20: Ethernet Protocols (CLI)
Parameter Input Type
group Variable
slot Number
port Number
erpi-id Number
Table 263 G.8032 ERPI Display Command Output Parameters
Parameter
ERPI ID
ERPI Name
Service
User Instance
Ring State
West SP
East SP
Permitted Values
rp1
rp2
rp3
rp4
lag1
lag2
lag3
lag4
mc-abc1
mc-abc2
mc-abc3
mc-abc4
1
ethernet: 1-6
radio: 1-2
management: 1-2
tdm: 1
1-64
Description
A unique ID that identifies the ERPI.
A descriptive name for the ERPI.
The ID of the Ethernet service to which the ERPI belongs.
The MSTI to which the Ethernet service is mapped.
Indicates the current ERPI state. Possible values are:
Initializing
Idle
Pending
Protecting
FS (Forced Switch)
MS (Manual Switch)
The interface to which the west ERPI service point belongs.
The interface to which the east ERPI service point belongs.
phn-3965_006v002
Page 20-10
Description
To display ERPIs that include a service point
on a 1+1 HSB group, a LAG group, or a
Multi-Carrier ABC group, use this parameter
instead of the interface, slot, and port
parameters to identify the group. See:
•
Configuring HSB Radio Protection (CLI)
•
Configuring Link Aggregation (LAG) and
LACP (CLI)
•
Configuring Multi-Carrier ABC (CLI)
The interface for which you want to display
ERPIs.
The ID of the ERPI for which you want to
perform or clear the switch, initiate
convergence, or display information.
Configuring G.8032 (CLI)