Chapter 9: TDM Services and Interfaces
Figure 337 PseudoWire Services – Information Page
Table 110
describes the pseudowire TDM service status parameters.
To clear the statistics, click Clear Statistics at the bottom of the page.
Table 110 Pseudowire TDM Service Status Parameters
Parameter
Shelf Slot ID
Service ID
Operational Status
Tx Packets
Rx Packets
LOPS Transitions
Jitter Buffer Overruns
Jitter Buffer Deviations
Minimum Jitter Buffer Count
Definition
Slot 1.
A unique ID that identifies the service. Once you have added the service,
you cannot change the Service ID.
Displays the current operational state of the service (Up or Down). If no
traffic is currently passing through the service, the Operational Status
displays Down. This does not necessarily mean there is anything wrong
with the unit or the configuration of the service.
The number of transmitted packets.
The number of received packets.
The number of transitions from normal state to Loss of Packet
Synchronization (LOPS) state.
The number of jitter buffer overruns.
The maximum jitter buffer deviation.
The minimum jitter buffer usage registered for the previous second.
phn-3965_006v002
Page 9-69
Configuring Advanced Pseudowire Parameters