Cambium Networks PTP 820 Series User Manual page 701

Chapter 14: Getting Started (CLI)
Configuring In-Band Management (CLI)
You can configure in-band management in order to manage the unit remotely via its radio and/or Ethernet
interfaces.
Each PTP 820 unit includes a pre-defined management service with Service ID 257. The management service is a
multipoint service that connects the two local management ports and the network element host CPU into a single
service. In order to enable in-band management, you must add at least one service point to the management
service, in the direction of the remote site or sites from which you want to access the unit for management. For
instructions on adding service points, see
Note
In order to use in-band management, it must be supported on the external switch.
Configuring Service Points (CLI).
phn-3965_006v002
Page 14-6
Configuring In-Band Management (CLI)