Cambium Networks PTP 820 Series User Manual page 811

Chapter 17: Radio Configuration (CLI)
radio [x/x]>modem excessive-ber show threshold
Table 164 Excessive BER CLI Parameters
Parameter Input Type
admin Variable
For example, the following command enables
root> radio excessive-ber set admin enable
To set the level above which an excessive BER alarm is issued for errors detected over the radio link, enter the
following command in radio view:
radio[x/x]>modem excessive-ber set threshold <threshold>
To display the excessive BER threshold, enter the following command in radio view:
radio[x/x]>modem excessive-ber show threshold
Table 165 Excessive BER Threshold Parameters (CLI)
Parameter Input Type
threshold Variable
The following command sets the excessive BER threshold for radio interface 2 to 1e-5:
radio[1/2]>modem excessive-ber set threshold 1e-5
Configuring RSL Thresholds (CLI)
You can set two RSL (RX Signal Level) thresholds. The number of seconds during which the RSL exceeds these
thresholds are counted as RSL Exceed Threshold Seconds. See
To set the RSL thresholds, go to radio view and enter the following command:
radio [x/x]>rf pm-rsl set threshold1 <threshold1> threshold2 <threshold2>
Permitted Values Description
enable Enables or disables propagation of excessive
BER as a fault.
disable
excessive-ber :
Permitted Values Description
1e -3 The level above which an excessive BER alarm
1e -4 is issued for errors detected over the radio
1e -5 link.
Displaying RSL and TSL Levels
phn-3965_006v002
Page 17-22
Configuring and Viewing Radio PMs and Statistics (CLI)
(CLI).