Cambium Networks PTP 820 Series User Manual page 836

Chapter 18: Ethernet Services and Interfaces (CLI)
Adding Service Point Examples (CLI)
The following command adds an SAP service point with Service Point ID 10 to Service 37, with interface type dot1q.
This service point is located on radio interface 1. VLAN ID 100 is classified to this service point.
service[37]>sp add sp-type sap int-type dot1q spid 10 interface radio
slot 1 port 1 vlan 100 sp-name Radio
The following command adds an SAP service point with Service Point ID 10 to Service 37, with interface type
bundle-c-tag. This service point is located on radio interface 2.
service[37]>sp add sp-type sap int-type bundle-c-tag spid 10 interface
radio slot 1 port 2 sp-name Radio
The following command adds an SAP service point with Service Point ID 10 to Service 37, with interface type qinq.
This service point is located on radio interface 1. S-VLAN 100 and C-VLAN 200 are classified to the service point.
service[37]>sp add sp-type sap int-type qinq spid 10 interface radio slot
1 port 1 outer-vlan 100 inner-vlan 200 sp-name Radio
The following command adds an SAP service point with Service Point ID 10 to Service 37, with interface type all-to-
one. This service point is located on radio interface 2. All traffic entering the system from that port is classified to
the service point.
service[37]>sp add sp-type sap int-type all-to-one spid 10 interface
radio slot 1 port 2 sp-name all-to-one
The following command adds an SNP service point with Service Point ID 10 to Service 37, with interface type
dot1q. This service point is located on radio interface 1. VLAN ID 100 is classified to this service point.
service[37]>sp add sp-type snp int-type dot1q spid 10 interface radio
slot 1 port 1 vlan 100 sp-name Radio
The following command adds an SAP service point with Service Point ID 7 to Service 36, with interface type dot1q.
This service point is connected to Radio Group 1 (rp1). VLAN ID 100 is classified to the service point.
service[36]>sp add sp-type sap int-type dot1q spid 7 group rp1 vlan 100
sp-name test1
The following command adds a Pipe service point with Service Point ID 1 to Service 1, with interface type dot1q.
This service point is located on Ethernet port 1.
service[1]>sp add sp-type pipe int-type dot1q spid 1 interface eth slot 1
port 1 sp-name pipe_dot1q
The following command adds a Pipe service point with Service Point ID 2 to Service 1, with interface type dot1q.
This service point is located on Ethernet port 2.
service[1]>sp add sp-type pipe int-type dot1q spid 2 interface radio slot
1 port 2 sp-name pipe_dot1q_radio
The following commands create a Smart Pipe service between Ethernet port 1 and Multi-Carrier ABC group 1. This
service carries S-VLANs and untagged frames between the two interfaces:
phn-3965_006v002
Page 18-17
Configuring Ethernet Services (CLI)