Cambium Networks PTP 820 Series User Manual page 667

Chapter 12: Alarm Management and Troubleshooting
5. In the Password in server field, enter the password you configured in the FTP server. If you did not
configure a password for your FTP user, simply leave this field blank.
6. If the IP address family is configured to be IPv4, enter the IPv4 address of the PC or laptop you are using as
the FTP server in the Server IP field. See
7. If the IP address family is configured to be IPv6, enter the IPv6 address of the PC or laptop you are using as
the FTP server in the IPv6 Server Address field. See
Communications.
8. In the Location of files in server field, enter the directory path to which you are uploading the file. Enter the
path relative to the FTP user's home directory, not the absolute path. To leave the path blank, enter //.
9. In the File Name in server field, enter the name you want to give to the exported Unit Information file.
10. Click Apply to save your settings.
11. Click Create to create the Unit Information file. The following fields display the status of the file creation
process:
o
Unit Info File Creation Status – Displays the file creation status. You must wait until the status is Success
to upload the file. Possible values are:
o
Ready – The default value, which appears when no file is being created.
o
Generating File – The file is being generated.
o
Success – The file has been successfully created. You may now upload the file.
o
Failure – The file was not successfully created.
o
Unit Info File Creation Progress – Displays the progress of the current Unit Information file creation
operation.
12. Click Export. The upload begins. The following fields display the status of the upload process:
o
Unit Info File Transfer Status – Displays the status of any pending Unit Information file upload. Possible
values are:
o
Ready – The default value, which appears when no file transfer is in progress.
o
File-in-transfer – The upload operation is in progress.
o
Success – The file has been successfully uploaded.
o
Failure – The file was not successfully uploaded.
If you try to export the file before it has been created, the following error message appears: Error #3-Invalid set
value.
If this occurs, wait about two minutes then click Export again.
o
Unit Info File Creation Progress – Displays the progress of the current Unit Information file upload
operation.
Defining the IP Protocol Version for Initiating
Defining the IP Protocol Version for Initiating
phn-3965_006v002
Page 12-17
Uploading Unit Info
Communications.