Cambium Networks PTP 820 Series User Manual page 773

Chapter 16: Unit Management (CLI)
Installing and Upgrading Software (CLI)
To install or upgrade the software, enter the following command in root view after downloading the software
bundle:
root> platform software install version
To display the status of an IDU software installation or upgrade, enter the following command:
root> platform software install status show
Installing and Upgrading Software in the RFU (CLI)
RFU software is installed and upgraded per carrier. After downloading a new software bundle, you must enter the
following two commands in root view to install the new RFU software version in a carrier:
root> platform software update rfu version slot <slot> radio-port <radio-
port>
root> platform software install rfu version slot <slot> radio-port
<radio-port>
To view the status of an RFU installation or upgrade procedure, enter the following command in root view:
root> platform software rfu status show
To display all RFU software versions currently running in the unit, enter the following command:
root> platform software show rfu versions
Table 151 RFU Software Upgrade CLI Parameters
Parameter Input Type
slot Number
port Number
After installing the new version, it is recommended that you verify the installation by entering the
software show rfu versions
The following sequence of commands installs RFU-C software version 2.13 in radio interface 1.
First, enter the following command to determine which software versions are available, and which software
versions are installed and running:
Permitted Values
1
1-2
command to verify that the new version has been properly installed.
phn-3965_006v002
Page 16-15
Upgrading the Software (CLI)
Description
platform