Cambium Networks PTP 820 Series User Manual page 399

Chapter 6: Ethernet Services and Interfaces
In addition, when a local triggering event takes place, the ASP mechanism sends an indication to the remote side of
the link. Even when no triggering event has taken place, the ASP mechanism sends periodic update messages
indicating that no triggering event has taken place.
A trigger delay time can be configured, so that when a triggering event takes place, the ASP mechanism does not
propagate the event until this delay time has elapsed. A trigger delay from 0 to 10,000 ms can be set per LLD ID.
The delay time must be configured via CLI. See
To configure an Automatic State Propagation interface pair:
1. Select Ethernet > Interfaces >ASP & LLF. The Automatic State Propagation page opens.
Figure 201: Automatic State Propagation Page
2. Click Add. The Automatic State Propagation - Add page opens.
Figure 202: Automatic State Propagation - Add Page
3. In the Controlled Ethernet interface field, select the interface that will be disabled upon failure of the
Monitored Radio Interface, defined below.
Configuring Automatic State Propagation and Link Loss
Configuring Automatic State Propogation and Link Loss Forwarding.
phn-3965_006v002
Page 6-28
Forwarding