Cambium Networks PTP 820 Series User Manual page 738

Chapter 15: Configuration Guide (CLI)
Configuring Multi-Carrier ABC for PTP 820G (CLI)
To configure a Multi-Carrier ABC group for PTP 820G (CLI):
1 Create the group by entering the following command in root view:
root> multi-carrier-abc create group group_id 1
multi-carrier-abc group-id [1]>
2 Enter Multi-Carrier ABC Group view by entering the following command in root view:
root> multi-carrier-abc group-id [1]
3 Add members to the group as follows:
o
To add a radio carrier to the group, enter the following command in Multi-Carrier ABC Group view. Repeat
this command for each radio carrier you want to add.
multi-carrier-abc group-id [1]> attach-member slot 2 port <port> channel-
id <1-16>
The Channel ID identifies the interface within the group.
4 Repeat for the second radio carrier.
The following commands create a Multi-Carrier ABC group.
root> multi-carrier-abc create group group_id 1
multi-carrier-abc group-id[1]> attach-member slot 2 port 1 channel-id 1
multi-carrier-abc group-id[1]> attach-member slot 2 port 2 channel-id 2
multi-carrier-abc group-id[1]> exit
Removing Members from a Multi-Carrier ABC Group (CLI)
To remove members from a Multi-Carrier ABC group:
1 To remove an individual radio carrier from the Multi-Carrier ABC group, go to Multi-Carrier ABC group view
and enter the following command:
multi-carrier-abc group-id[1]> detach-member channel-id <channel-id>
2 To remove a protection group member from the Multi-Carrier ABC group, go to Multi-Carrier ABC group
view and enter the following command:
multi-carrier-abc group-id[1]> detach-group channel-id <channel-id>
Deleting a Multi-Carrier ABC Group (CLI)
Note
For instructions on deleting a Multi-Carrier ABC/HSB-SD group, see
Group with Space Diversity
To delete a Multi-Carrier ABC group:
(CLI).
phn-3965_006v002
Page 15-7
Configuring Multi-Carrier ABC (CLI)
Deleting an HSB Radio Protection