Cambium Networks PTP 820 Series User Manual page 702

Chapter 14: Getting Started (CLI)
Changing the Management IP Address (CLI)
Related Topics:
•
Defining the IP Protocol Version for Initiating Communications (CLI)
•
Configuring the Remote Unit's IP Address (CLI)
You can enter the unit's address in IPv4 format and/or in IPv6 format. The unit will receive communications
whether they were sent to its IPv4 address or its IPv6 address.
To set the unit's IP address in IPv4 format, enter the following command in root view to configure the IP address,
subnet mask, and default gateway:
root> platform management ip set ipv4-address <ipv4-address> subnet
<subnet> gateway <gateway> name <name> description <name>
Table 127 IP Address (IPv4) CLI Parameters
Parameter Input Type
ipv4-address Dotted decimal format.
subnet Dotted decimal format.
gateway Dotted decimal format.
name Text String.
description Text String.
To set the unit's IP address in IPv6 format, set in root view the IP address, prefix length, and default gateway of the
PTP 820G or PTP 820F unit, as follows:
root> platform management ip set ipv6-address <ipv6-address> prefix-
length <prefix-length> gateway <gateway>
Note
It is recommended not to configure addresses of type FE:80::/64 (Link Local addresses) because traps
are not sent for these addresses.
Permitted Values
Any valid IPv4 address.
Any valid subnet mask.
Any valid IPv4 address.
phn-3965_006v002
Page 14-7
Changing the Management IP Address (CLI)
Description
The IP address for the
unit.
The subnet mask for the
unit.
The default gateway for
the unit (optional).
Enter a name (optional).
Enter a description
(optional).