Cambium Networks PTP 820 Series User Manual page 861

Chapter 18: Ethernet Services and Interfaces (CLI)
root> auto-state-propagation add eth-port-to-multi-radio-group eth-slot 1
eth-port 1 multi-radio-group 1
root> auto-state-propagation configure eth-port eth-slot 1 eth-port 1
asp-admin enable remote-fault-trigger-admin enable csf-mode-admin disable
The following commands configure and enable automatic state propagation to propagate faults from 1+1 HSB
protection group 1 to Ethernet port 2. Faults on the remote carrier are not propagated to Ethernet port 2. CSF
mode is disabled.
root> auto-state-propagation add eth-port-to-protection-group eth-slot 1
eth-port 2 protection-group 1
root> auto-state-propagation configure eth-port eth-slot 1 eth-port 2
asp-admin enable remote-fault-trigger-admin disable csf-mode-admin
disable
The following commands configure and enable automatic state propagation to propagate faults from radio
interface 2 to LAG group 1. Faults on the remote carrier are also propagated to LAG group 1. CSF mode is disabled.
root> auto-state-propagation add lag-to-radio lag-id 1 radio-slot 1
radio-port 2
root> auto-state-propagation configure lag lag-id 1 asp-admin enable
remote-fault-trigger-admin enable csf-mode-admin disable
Configuring Automatic State Propagation and Link Loss
phn-3965_006v002
Page 18-42
Forwarding (CLI)